Motherhood operating systems in progress.

This area does not yet contain any content.
Find Us On...
Subscribe to MommyBeta
Latest Tweets
Join My Parenting Book Club!

Entries in Ornament (1)


Homemade Christmas Ornaments


Last year, I made adorable handprint ornaments for all of Nic’s grandparents, God parents, aunts and uncles. They were a big hit. So this year, when I got an email from Factory Direct Craft offering tips on Christmas projects, I jumped right on their suggestion to make personalized, filled ornaments.

Factory Direct Craft graciously sent me the craft supplies to make these lovely ornaments, and below I’ll go through their construction, step by step.

What you need: 

Step #1: Print Photos

Select two cute holiday-appropriate photos. You’ll need one for each side of the ornament.  I used Picnik to add some text to one of my photos.

Step #2: Trace and Cut

Using one half of the ornament as your guide, trace a circle on to each picture maximizing what you want visible. Cut out these circles.

Use double-sided tape to stick each set of images together.  Make sure they are lined up correctly (both heads are pointing the same direction for instance).

Step #3: Decorate Photos

One of my photos couldn’t be cropped in a way that would avoid showing half of my husband.  It looked a little funny, so decided to decoupage over him (he wanted me to!)!  A bit of Mod Podge and some snowflakes did the trick.

Step #4: Fill Ornaments

Open up the ornaments and sprinkle some confetti into each side. (I forgot to do this one about half of mine and am bummed about it.  Don’t forget this cute step!)

This next bit is the only tricky part of the whole project. Fit the double-sided photo neatly inside the “female” side of the snowflake.  It might take a little trimming and some patience, but it actually will slide in there nicely.  Once it’s in place, slide the other side on snuggly.

Step #5: Ribbon

Cut approximately 20 inch sections of ribbon.  Fold the section in half longwise and then again in half widthwise, thread this through the BACK of the loop at the top of the ornament.  Leave a nice sized loop for hanging and then tie a knot at the front of the hanging loop.  Then make a bow.  Tying it this way ensures that the bow stays at the bottom front of the ornament.

Step #6: Decoupaging the Outside

I wanted to give them one final touch, a ring of snowflakes around the outside.  I also figured the Mod Podge should seal the ornaments shut.  Hang the ornaments if you can (I used a laundry drying rack, which worked great).  Do a stripe of Mod Podge along the seam of half of the ornament.  Place a few confetti pieces along the glue.  Repeat on other side. (Doing one side at a time prevents the glue from drying before you get your confetti on). Let hang to dry.  The Mod Podge does dry clear, but try not to goop it on or it will be visible.

I enlisted a bit of help with the snowflakes.


You have cute, inexpensive and personal ornaments for your nearest and dearest.